Reasons For Bathtub Reglazing

Bathtub Reglazing is Necessary When Peeling:

Bathtub reglazing may be needed if your bathtub has a large peeling marks. Most often peeling marks occur when the chemical bond is broken down due to the fact that the tub has been improperly reglazed. Peeling marks are basically paint that is slowing coming off of the tub and will continue to get worse. Especially if u have children it is very important to strip and reglaze your bathtub as soon as possible to avoid your child from getting cut from the flaking resurfacing product or in some cases the child eating paint chips.

Bathtub Reglazing is Necessary When Chipping:

Bathtub glazing may be needed if you have chips in the surface of the porcelain. Porcelain will chip off in chunks and is razor sharp. Bathtub reglazing will solve your problems of your tub chipping. It is best to professionally reglaze your tub to avoid any rust spots or further deterioration of the surface.

Bathtub Reglazing is Necessary When The Tub is No Longer Shining:

Bathtub reglazing may be a great solution to your tub that has no shine to it. Reglazing your tub will add a new shine to the surface.

Bathtub Reglazing is Necessary When You Can’t Get the Tub Clean:

If your can’t get your bathtub clean bathtub reglazing is perfect for you if done properly. Just think of pottery class you glaze your project and fire it in a kiln. Glazing your project creates a shinny surface sealing it and allowing you to clean it or drink from it. Bathtub reglazing is needed when abrasive cleaners are applied to the surface over time. Once the glaze is worn off the surface the porcelain is porous allowing dirt and soap scum to stick in the pours of the porcelain. I bet the out side of your bathtub still has the glaze on the surface. Nobody cleans the outside of their bathtub with abrasive cleaners.

Bathtub Reglazing is Necessary When The Tub Changes Colors:

Need too get rid of your old pink, blue, green or red tub then bathtub reglazing is perfect for you if it is done right.

Bathtub refinishing also known as bathtub resurfacing, bathtub reglazing or bathtub re-enameling is the process of refreshing the surface of a worn, damaged bathtub to a like-new condition. This process typically involves repairing any damaged areas. Chips or cracks are repaired using Bondo or another type of polyester putty. After repairs are made the surface is prepped with an acid etching. Etching provides mechanical adhesion. Porcelain, enamel, and fiberglass tubs are non-porous and do not provide a good substrate for the new coating to attach to. Etching the surface provides a porous surface that will allow proper adhesion. Another possible method is to apply an adhesion-promoting bonding agent like silane to the surface before applying the coating. The two methods can be used in unison or independently. The greatest adhesion is achieved by using both methods together. Some new refinishing processes do not require the use of etching, by relying on silane alone. After preparing the surface, primer is applied, followed by a top coat. Generally, a catalyzed two-component cross-link synthetic white coating is applied, but the coating does not have the durability or abrasive tolerance of the original glass-enamel coating of a factory-new bathtub.

Coatings used to create a new bathtub finish can be epoxies, urethanes, hybrid polyester-polyurethane, or polymers. These coatings may be rolled, brushed, or sprayed on.

Bathtub refinishing is possible using DIY kits from hardware stores, but some may choose a professional service company offering refinishing services. DIY kits generally do not offer the same level of bonding and thus, deteriorate more quickly, relying primarily on epoxy adhesion. Without professional spray equipment, the final aesthetic look may show brush or roller marks.

Leave a Reply